Electronic control fuel injection system (Common rail type) 1E-417 Step Action Value YES NO 17 Check the DTC again. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3. Start the engine, and run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC P1094 detected? — Go to Step 2. Go to Step 18. 18 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 19 1. Turn the key switch to “OFF”. 2. Disconnect the common rail pressure sensor connector. 3. Turn the key switch to “ON”. 4.
Connect the DMM between the common rail pressure sensor connector power supply terminal and the ground. Is the DMM indication more than the specified value? 4.8V Go to Step 8. Go to Step 20. 20 1. Check the signal circuit between common rail pressure sensor and ECM for short circuit to signal circuits of other sensors using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 17. Go to Step 21. 21 Check the injector using injector checker.
Refer to “How to use injector checker” in this section for how to use injector checker. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 11. Go to Step 12.