hitachi — DTC: P1094 (Flash code 226) No pump pressure feed (1st stage)

1E-416 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 11 Replace the injector in the cylinder of which engine sound did not change when it is stopped in step 9. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 17. — 12 Replace the supply pump. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 13. — 13 Check the DTC again. 1. Bleed air from the fuel system. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3.

Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P1094 detected? — Go to Step 14. Go to Step 18. 14 Is EMPS available? — Go to Step 15. Go to Step 16. 15 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 17. Go to Step 16. 16 Replace the ECM.

Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 17. —