Electronic control fuel injection system (Common rail type) 1E-415 Step Action Value YES NO 7 1. Turn the key switch to “OFF”. 2. Disconnect the common rail pressure sensor connector. 3. Turn the key switch to “ON”. 4. Check for “Common rail pressure sensor” on the data display using scan tool. Is the “Common rail pressure sensor” more than the specified value? 4.8V Go to Step 8. Go to Step 9. 8 Replace the common rail (common rail pressure sensor). Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 17. — 9 1.
Check the signal circuit between common rail pressure sensor and ECM for short circuit to signal circuits of other sensors using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 17. Go to Step 10. 10 1. Connect the common rail pressure sensor connector. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Start the engine. 4. Select the “Actuator test” from the menu. 5.
Select the “Injection stop at each injector” in the “Common rail system”. 6. Press the “OFF” soft key to stop the fuel injection in the cylinder one by one, and check the change in engine sound. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 11. Go to Step 12.