1E-422 Electronic control fuel injection system (Common rail type) Fuel system filter DTC set condition When pressure limiter is opened. When common rail pressure is more than 200 MPa (29008 psi) for 1 second or more. DTC set condition in the case of high common rail pressure is described below. Only P1095 is detected if the fuel pressure overshoots due to entry of air. 3 4 2 5 Common rail presure T>1sec=P1095 1 200 MPa (29008psi) TSWG0159 155 MPa (22481psi) 150 MPa (21756psi) T Name 1. Fuel pump strainer 2. Pre-fuel filter 3. Main fuel filter 4. Electromagnetic pump filter 5. Gauze filter T>5sec=P0088 T Filter clogging in the fuel system may establish the DTC set condition.
Check as required. Action taken when DTC is set TSWG0179 Preconditions when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Key switch input voltage is 16V or more. DTC P1095, P0192, P0193, P1630, or P1635 is not detected. 50 rpm or more Back-up mode Limited injection amount 1 Output goes down to about 50% since fuel flow is limited. Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure).
The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs.