hitachi — DTC: P1095 (Flash code 225) Pressure limiter open

Electronic control fuel injection system (Common rail type) 1E-423 Diagnostic aid Fuel tank fault (temporary clogging, air mixed due to fuel shortage, air mixed due to modified fuel pipe for additional tank etc.) Pressure limiter trouble (operation under specified pressure, degradation of sealability) ECM trouble Common rail pressure sensor trouble Running out of fuel Followings are suspected as the cause. Air mixed in the high-pressure fuel pipe.

Injector internal trouble Supply pump internal trouble Fuel system pipe fault (clogging etc.) Fuel filter fault (temporary clogging due to waxing at low temperatures, improper tightening of filter cartridge, etc.) Test description Numbers below indicate step numbers in the chart. 8. If the “Common rail pressure sensor” displays more than the specified value when the common rail pressure sensor connector is removed, the circuit beyond the sensor is normal including ECM. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check the DTC again. 1. Check and record the DTC. 2. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Check the fuel amount, and add fuel as required. If fuel is low, P1095 may be detected due to entry of air. 4. Bleed air from the fuel. • If air bleeding is insufficient, overshoot exceeds 200 MPa (29008 psi) and DTC will be detected. Note: • Bleeding air from fuel must be performed correctly, following the procedure. • For work procedure, refer to “Engine section” in the service manual. 5. Race it quickly for about 5 times. 6. Check the DTC. Is DTC P1095 detected? — Go to Step 3. Refer to “Diagnostic aid” and Go to Step 4.