1E-424 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 3 Narrow down the cause. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Connect another pipe to the supply pump inlet duct, and test run while supplying fuel. (At this time, replace the fuel hose with a transparent hose to visually check for air mixture in the fuel.) 3. Check the DTC. Is DTC P1095 detected? — Go to Step 16. Go to Step 4. 4 Check the fuel system in the following procedure. 1.
Check the high pressure pipe and low pressure pipe for looseness in the connection (fuel leakage), crush or clogging. Check the clogging in the following procedure. • Fuel filter (main fuel filter, pre-fuel filter, gauze filter) • Fuel tank (pump strainer) • Fuel system pipe 2. Check the fuel pipe, fuel filter, and inside of the fuel tank for freeze or waxing. (at cold temperature) 3. Check the feed pipe inside the fuel tank for clogging of foreign matter. Is the fuel system normal? — Go to Step 6. Go to Step 5. 5 Repair or replace the faulty part. Is the procedure completed? — Go to Step 17. — 6 Is the scan tool (KW communication) available? — Go to Step 7. Go to Step 20.
7 Check the common rail pressure. 1. Turn the key switch to “ON”. 2. Check for “Differential fuel rail pressure” on the data display using scan tool. 3. Start the engine and run it at idle. 4. Check for “Differential fuel rail pressure” on the data display using scan tool. 5. Race it quickly for about 5 times. 6. Check for “Differential fuel rail pressure” on the data display using scan tool. Is each value of “Fuel rail pressure” (at engine stopped, idling and racing) around the specified value? At engine stopping: −30 MPa (− 4351 psi); At idling, racing: ±5 MPa (±725 psi) Go to Step 14. Go to Step 8.