hitachi — DTC: P1095 (Flash code 225) Pressure limiter open

Electronic control fuel injection system (Common rail type) 1E-425 Step Action Value YES NO 8 1. Turn the key switch to “OFF”. 2. Disconnect the common rail pressure sensor connector. 3. Turn the key switch to “ON”. 4. Check for “Common rail pressure sensor” on the data display using scan tool. Is the “Common rail pressure sensor” specified value? 0V Go to Step 13. Go to Step 9. 9 1. Check the signal circuit between common rail pressure sensor and ECM for short circuit to signal circuits of other sensors using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2.

If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 18. Go to Step 10. 10 Is EMPS available? — Go to Step 11. Go to Step 12. 11 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. Go to Step 12. 12 Replace the ECM. Note:

EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. — 13 Replace the common rail (common rail pressure sensor). Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 18. —