hitachi — DTC: P1095 (Flash code 225) Pressure limiter open

1E-426 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 14 Check the DTC again. 1. Restore the machine. 2. Bleed air from the fuel. 3. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P1095 detected? — Go to Step 15. Go to Step 19. 15 1. Replace the common rail. Note: For work procedure, refer to “Engine section” in the service manual. 2. Bleed air from the fuel. 3. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P1095 detected? — Go to Step 16. Go to Step 18. 16 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Start the engine. If Tech2 is available, go to step 3. If Tech2 is not available, go to step 17. 3. Select the “Actuator test” from the menu. 4. Select the “Rail pressure control” in the “Common rail system”. 5. Press the “Up” soft key to check the value of “Differential fuel pressure”.

Is “Differential fuel rail pressure” within the specified value? ±5 MPa (±725 psi) Go to Step 18. Go to Step 17. 17 Replace the supply pump. Note: • Bleed air completely after the parts are replaced. If air bleeding is not sufficient, P1095 may be detected due to overshoot of fuel pressure. • For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 18. —