hitachi — DTC: P1095 (Flash code 225) Pressure limiter open

1E-428 Electronic control fuel injection system (Common rail type) Characteristics of common rail pressure sensor Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. 4.2 (V) 1 0 200(29008) MPa(psi) TSWG0201 Name 1. Breaker box 2. DMM On-board check procedure for sensors Name 1. Coupling connector between engine — the machine 2. Machine harness 3. Sensor connector 4. Engine harness 3 1. Disconnect the coupling connector, and check the sensor from engine harness connector. 2.

Disconnect the connector from sensor, and short the wiring of sensor connector. 3. Check the harness from coupling connector for open circuit. If both steps 1 and 2 are faulty, repair the harness. Check from step 1 again. If only step 1 is faulty, replace the sensor. 1 2 4 TSWG0197 Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 9 Short circuit to other signal circuit Voltage measurement • Disconnect the sensor connector. • Key switch “ON” 82 - Ground 90 - Ground 0V 1V or more