Electronic control fuel injection system (Common rail type) 1E-429 DTC: P1112 (Flash code 295) Boost temperature sensor fault (low voltage fault, ground short) 5V Boost pressure sensor signal Engine control module (ECM) 5V Boost temperature sensor signal 74 E-56 91 E-56 E-56 95 E-56 109 15 H-20 H-20 17 8 H-20 16 H-20 0.75 R/W 0.75 R/L 0.75 L 0.75 B/R 0.75 R/L 2 E-163 E-163 1 1 E-75 2 E-75 3 E-75 Boost temperature sensor Boost pressure sensor TSWG0079 Description of circuit Preconditions when DTC is set The boost temperature sensor is installed to the intake manifold. The resistance value of boost temperature sensor changes according to the temperature in intake manifold.
The resistance is low when the intake air temperature is high, and is high when the temperature is low. The ECM energizes 5 V to the boost temperature sensor through the pull up resistance, and calculates the boost temperature from the change in voltage, to utilize various control such as fuel injection control. If the resistance is low (temperature is high), the voltage becomes low; if the resistance is high (temperature is low), the voltage becomes high. Key switch input voltage is 16V or more. DTC P1634 is not detected. DTC set condition Boost temperature sensor voltage is 0.1 V or less.
Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Back-up mode Back-up: No back-up action Operationality is not affected.