Electronic control fuel injection system (Common rail type) 1E-39 F1: Any Code: Data is saved in case any trouble code is issued. 2. Move the highlight bar to the data you want replayed, and press the [ENTER] key. The data will be replayed. F2: Single Code: Data is saved in case the specified trouble code is issued. About trigger point: Trigger Point corresponds to the point in time where triggering is originated by a code issued or by Manual Trigger activated. This information is useful to know the time point of Snap Point and to investigate changes in the data parameter. Trigger Point can be set up at “Beginning”, “Center”, or “End.” F4:
Beginning Starts saving data from Trigger Point, and keeps on saving it, until the Snapshot recording area is filled up. This selection is effective when the trouble that constitutes the cause is foreseeable. F5: Center This function is commonly utilized, since it saves not only the data after Trigger Point, but also those prior to that. This selection allows to compare data that existed before the occurrence of a trouble, those present at the time of occurrence of the trouble, and those after the trouble, among themselves. TSWG0102 Note: Flashing “Trigger” means that data is being recorded. Pressing the [EXIT] key in this condition will abort the recording.
The recording will also be cancelled when the memory capacity is filled up. In either case, the data is saved in memory. F6: End Saves only the data prior to Trigger Point. This selection is useful when it is desired to terminate Snapshot after the occurrence of a trouble. Plot Snapshot data replay Snapshot can also be replayed in “View Captured Data.” 1. Press the softkey “Review Data” on the “Snapshot Options” screen. Plot setup procedure 1. Pressing the softkey “Plot” switches the “Data Display” screen. RPM MPa V V RPM V V % TSWG0101 TSWG0103