1E-38 Electronic control fuel injection system (Common rail type) TSWG0099 Snapshot Snapshot 1. Select “F2: Snapshot” on the “Engine” screen. Snapshot is intended to save information received by the machine controller during its execution. It provides an effective means to analyze data generated when the machine encounters a trouble. Use of this function enables the user to focus on the situation in which the trouble took place, without having to view all the data for suspected malfunctions. The Tech2 is capable of holding two different Snapshot data. This ability of storing two different Snapshot data allows to compare Good and Bad machine states with each other.
Since these data are saved on a first-in, first-out basis, the first Snapshot data (of older date/time) stored on the PCMCIA card will be lost as it is overwritten when a third data comes in. Therefore, be sure to set the internal clock of the Tech2 precisely before starting the Tech2. If a given data must not be erased, highlight that data and choose the softkey “Write Protect”. This prevents the data from being overwritten. Pressing the softkey “Clear” cancels the protect. 2. Choosing “F2: Snapshot”, the following menu is displayed. F0: Manual Trigger F1: Any Code F2: Single Code F4: Beginning F5: Center F6: End TSWG0100 Snapshot is available in the following 2 types: Snapshot:
To be chosen in the Snapshot Menu. Quick Snapshot: To be chosen through the softkey on the “Data Display” screen. The Snapshot Data will not be lost even when the Tech2 is switched off, because the data is saved on the PCMCIA card. About trigger type: Choosing the Trigger Type Menu allows to check the cause that triggered [Snapshot]. [Snapshot] is executed when there is one of the three causes of occurrence. F0: Manual Trigger: Pressing the softkey “Trigger” saves data. V V RPM RPM V V % MPa V V RPM RPM V V % MPa