hitachi — DTC: P1113 (Flash code 295) Boost temperature sensor fault (high voltage fault, open circuit, short to power supply circuit)

Electronic control fuel injection system (Common rail type) 1E-439 Step Action Value YES NO 5 1. Check the signal circuit between ECM and boost temperature sensor for short circuit to the power supply circuit or ignition power supply circuit, using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. Important: If the boost temperature sensor circuit is shorted to the power supply circuit, the sensor may be broken. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 11. Go to Step 6. 6 1.

Check for followings in the ground circuit between ECM and boost temperature sensor, using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 11. Go to Step 8. 7 Replace the boost temperature sensor. Is the procedure completed? — Go to Step 11. — 8 Is EMPS available? — Go to Step 9. Go to Step 10. 9 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary.

Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. Go to Step 10.