hitachi — DTC: P1113 (Flash code 295) Boost temperature sensor fault (high voltage fault, open circuit, short to power supply circuit)

1E-440 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 10 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 11. — 11 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC.

Is DTC P0238 detected? — Go to Step 2. Go to Step 12. 12 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 13 1. Start the engine. 2. Check the display of boost temperature. Does the display of “Boost temperature” show error value? 214°C (419°F) (Displayed error value) Go to Step 14. Go to “Diagnostic aid”. 14 Check for installation condition of the boost temperature sensor connector, ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 11. Go to Step 15. 15 1.

Check for followings in the ground circuit between ECM and boost temperature sensor, using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 11. Go to Step 7.