1E-444 Electronic control fuel injection system (Common rail type) DTC: P1173 (Flash code 542) Overheat (*: Specifications vary depending on each machine.
Refer to the machine’s manual.) Engine control module (ECM) Vehicle speed sensor signal Engine oil pressure sensor signal SV SV SV CKP HIGH signal CKP LOW signal Fuel temperature sensor signal Engine coolant temperature sensor signal Vcc 108 E-56 19 E-57 107 E-56 106 E-56 83 E-56 84 E-56 79 E-56 67 E-56 80 E-56 3 H-6 H-20 H-20 H-20 H-20 7 11 10 9 0.75 B/Y 0.75 L/Y 0.75 W/B 3 H-20 H-20 H-20 2 1 0.75 Y/G 0.75 B/Y 0.75 R/B 0.75 B/Y 0.75 B 2 E-93 1 E-93 1 E-90 2 E-90 1 E-76 E-76 E-76 2 3 0.5 V/W 0.5 Y Pulse matching box 2 E-98 1 E-98 Engine coolant temperature sensor Fuel temperature sensor Engine oil pressure sensor 3 E-90 CKP sensor * A 0.75 R CAN HIGH CAN LOW Engine control module (ECM) Vehicle speed sensor 37 E-57 18 E-57 4 H-6 A Meter Machine control unit Engine coolant temperature gauge CAN HIGH CAN LOW Machine trouble diagnosis monitor TSWG0078 Description of circuit The engine coolant temperature (ECT) sensor is installed in the thermostat housing.
The ETC sensor is the thermistor-type sensor, and the value of resistance and output voltage change according to the engine coolant temperature. As the engine coolant temperature increases, the resistance becomes small, and the voltage lowers. The ECM detects the engine coolant temperature based on the signal from the ECT sensor to perform various controls. The ECM sets the DTC when it judges that the engine coolant temperature exceed certain level based on the signal from the ECT sensor. 100% (226 ) Fuel fiow (248 ) Main trouble symptom Output lowering Fuel flow is regulated during overheat when the temperature exceeds 108 ° C (226 ° F). Engine coolant temperature (221 ) TSWG0169