Electronic control fuel injection system (Common rail type) 1E-445 Preconditions when DTC is set Diagnostic aid Key switch input voltage is 16V or more. DTC P1630, P1633, P0117, or P0118 is not detected. Engine under operation If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted.
Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. DTC set condition Engine coolant temperature is more than 120 ° C (248 ° F). Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode Back-up: No back-up action Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.
Test description The conditions to clear the MIL/DTC Numbers below indicate step numbers in the chart. 4. If the “Engine coolant temperature sensor” displays less than the specified value when the ECT sensor connector is removed, the sensor is faulty. 9. If no DTC is detected, intermittent trouble is suspected. Identify the cause by referring to “Diagnostic aid”. The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again.
Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 1. Start the engine. 2. Check the DTC. Is DTC P0088, P1093, or P1094 not detected? — Go to the relevant DTC detected. Go to Step 3. 3 Is the scan tool available? — Go to Step 4. Go to Step 14. 4 1. Turn the key switch to “OFF”. 2. Disconnect the ECT sensor connector. 3. Turn the key switch to “ON”. 4. Check for “Engine coolant temperature sensor” on the data display using scan tool. Is the “Engine coolant temperature sensor” more than the specified value?
4.9V/−40°C (−40°F) Go to Step 6. Go to Step 5.