hitachi — DTC: P1173 (Flash code 542) Overheat

1E-446 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Check the signal circuit between ECT sensor and ECM for short circuit to signal circuits of other sensors using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 10. 6 1. Check the engine coolant amount. 2. If insufficient, add engine coolant. 3. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 4.

Turn the key switch to “OFF” for more than 10 seconds. 5. Start the engine, and check the DTC. Is DTC P1173 detected? — Go to Step 7. Go to Step 13. 7 1. Check for following mechanical defects. (Refer to “Cooling system” of “Engine section” in the service manual.) • Clogging of radiator • Defective radiator cap • Loose fan belt • Defective thermostat • Defective water pump • Defective cylinder head gasket 2. If the trouble is detected, adjust or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 8. 8 Replace the ECT sensor. Is the procedure completed? — Go to Step 13. — 9 Check the DTC again. 1. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3. Test run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC P1173 detected? — Go to Step 10. Go to “Diagnostic aid”. 10 Is EMPS available? — Go to Step 11. Go to Step 12.