Electronic control fuel injection system (Common rail type) 1E-447 Step Action Value YES NO 11 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. Go to Step 12. 12 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.
Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. — 13 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 14 1. Turn the key switch to “OFF”. 2. Disconnect the ECT sensor connector. 3. Turn the key switch to “ON”. 4. Check the display of the “Engine coolant temperature”. Is the “Engine coolant temperature” more than the specified value? −40°C (−40°F) Go to Step 6. Go to Step 5.