1E-450 Electronic control fuel injection system (Common rail type) DTC: P1225 (Flash code 31) Idle UP/DOWN switch fault (*: Specifications (fuse current value etc.) vary depending on each machine.
Refer to the machine manual.) Key switch (ON) (15A)* Idling selector switch Mode map switch 2 Mode map switch 1 Mode map switch 0 Idle down switch Idle up switch 29 E-57 30 E-57 31 E-57 25 E-57 34 E-57 48 E-57 Engine control module (ECM) Mode map switch 2 signal Mode map switch 1 signal Mode map switch 0 signal Idle down switch signal Idle up switch signal Idling selector switch signal TSWG0082 Description of circuit DTC set condition The idling control switch is provided to adjust idle speed during warming-up, and is available for use when the idling control selector switch is in “Manual”. The power supply voltage is supplied to the idling control switch through the key switch.
By pressing the “Up” or “Down”, each ground circuit is completed and the signal is input to the ECM. The ECM sets the DTC when the signal inputs are detected for idling control switch “Up” side and “Down” side at the same time. When both of idling control up signal and idling control down signal are ON. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode Main trouble symptom Unable to change the speed in mode driving Operationality is not affected. Recovery from failure Preconditions when DTC is set Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.
Key switch input voltage is 16V or more.