Electronic control fuel injection system (Common rail type) 1E-451 The conditions to clear the MIL/DTC Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part.
The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid If the intermittent trouble is suspected, followings may be the cause. Fault in switch body Improper adjustment of switch Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Test description Numbers below indicate step numbers in the chart. 3.
If the “Idle up switch” and “Idle down switch” display “OFF” when the idling control switch connector is removed, the circuit is shorted between idle up circuit and idle down circuit, or the switch is faulty. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Is the scan tool available? — Go to Step 3. Go to Step 4. 3 1. Turn the key switch to “OFF”. 2. Disconnect the idling control switch connector. 3. Turn the key switch to “ON”. 4. Check for “Idle up switch” and “Idle down switch” on the data display using scan tool. Are the “Idle up switch” and “Idle down switch” displayed “OFF”? — Go to Step 6. Go to Step 4.
4 1. Check the idle up-side circuit between idling control switch and ECM for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 10. Go to Step 5.