hitachi — DTC: P1261 (Flash code 158) Injection nozzle common 1 drive system fault

Electronic control fuel injection system (Common rail type) 1E-455 Back-up mode Diagnostic aid • Specified back-up value If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage.

Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again.

Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 1. Turn the key switch to “OFF”. 2. Remove the ECM-side harness connector from the coupling connector (H-94). 3. Connect the DMM between the injector power supply 1 circuit (H94 female-side No. 3) and the ground. 4. Turn the key switch to “ON”. Is the DMM indication more than the specified value? 7.0V Go to Step 3. Go to Step 4. 3 1. Turn the key switch to “OFF”. 2. Remove the ECM-side harness connector from the coupling connector (H-94). 3.

Measure the resistance between the injector harness connector terminals (H94 male-side No. 3 and No. 4). Is the resistance less than the specified value? 1.0Ω Go to Step 6. Go to Step 22. 4 Check for installation condition of the injector harness connector, ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 27. Go to Step 5.