hitachi — DTC: P1261 (Flash code 158) Injection nozzle common 1 drive system fault

1E-456 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Check for followings in the injector power supply 1 circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance • Short circuit to ground 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 27. Go to Step 24. 6 1. Turn the key switch to “OFF”. 2. Remove the ECM-side harness connector from the coupling connector (H-94). 3. Measure the resistance between the No. 1 cylinder injector drive circuit (H94 male- side No.

2) and the ground. Is the resistance more than the specified value? 10MΩ Go to Step 7. Go to Step 9. 7 1. Turn the key switch to “OFF”. 2. Remove the ECM-side harness connector from the coupling connector (H-94). 3. Measure the resistance between the No. 2 cylinder injector drive circuit (H94 male- side No. 7) and the ground. Is the resistance more than the specified value? 10MΩ Go to Step 8. Go to Step 10. 8 1. Turn the key switch to “OFF”. 2. Remove the ECM-side harness connector from the coupling connector (H-94). 3. Measure the resistance between the No. 3 cylinder injector drive circuit (H94 male- side No. 6) and the ground. Is the resistance more than the specified value?

10MΩ Go to Step 12. Go to Step 11.