1E-470 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 21 1. Check the injector power supply 2 circuit between ECM and coupling connector (H-95) for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 27. Go to Step 24. 22 Replace the injector harness. Is the procedure completed? — Go to Step 27. — 23 Replace the injector. Note:
For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 27. — 24 Is EMPS available? — Go to Step 25. Go to Step 26. 25 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 27. Go to Step 26. 26 Replace the ECM. Note:
EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 27. —