hitachi — DTC: P1271 (Flash code 24) Accelerator sensor 1-2 comparison fault

1E-474 Electronic control fuel injection system (Common rail type) DTC: P1271 (Flash code 24) Accelerator sensor 1-2 comparison fault A A Engine control module (ECM) CAN HIGH CAN LOW 37 E-57 18 E-57 60 E-57 20 E-57 41 E-57 63 E-57 42 E-57 64 E-57 61 E-57 71 E-57 72 E-57 Machine control unit CAN HIGH CAN LOW 6 FL-167 5 FL-167 4 FL-167 6 FL-167 5 FL-167 4 FL-167 1 FL-269 2 FL-269 3 FL-269 2 FB-124 1 FB-124 Intake air temperature sensor Barometric pressure sensor Accelerator position sensor TSWG0081 Description of circuit The ECM provides 5 V to the AP sensor through 5-V power supply circuit, and grounds to the inside of the ECM through ground circuit.

Also, the AP sensor outputs the signal voltage to the ECM through AP sensor signal circuit. When the accelerator opening angle is large, the AP sensor 1 outputs high voltage, whereas the AP sensor 2 outputs low voltage. The ECM sets the DTC when the difference in the accelerator opening angle is large between which is detected based on the AP sensor 1 signal, and which is detected based on the AP sensor 2 signal. The accelerator position (AP) sensor is installed to the accelerator pedal. The AP sensor is the potentiometer- type sensor, and the value of output voltage changes according to the accelerator opening angle. Two AP sensors are installed, each of which includes following circuits.

5-V power supply circuit Ground circuit AP sensor signal circuit Main trouble symptom 1 system fault: No backup 2 systems fault: Accelerator opening angle is controlled to 0%. Accelerator Accelerator position position sensor 1 signal sensor 2 signal 5V Intake air Barometric pressure temperature sensor signal sensor signal 5V Vcc