hitachi — DTC: P1271 (Flash code 24) Accelerator sensor 1-2 comparison fault

Electronic control fuel injection system (Common rail type) 1E-475 Preconditions when DTC is set The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Key switch input voltage is 16V or more. DTC P1630, P1631, P1271, P1277, P1278, P1282, or P1283 is not detected. DTC set condition Difference in opening angle between accelerator sensors 1 and 2 is 45% or more. [Accelerator sensor 1 voltage + Accelerator sensor 2 voltage] is higher than 6.4 V. [Accelerator sensor 1 voltage + Accelerator sensor 2 voltage] is lower than 3.6 V.

Diagnostic aid If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor.

The variation of the display indicates the faulty part. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode 1 system fault...No back-up 2 system fault...Accelerator opening angle is controlled to 0%. Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC Test description Numbers below indicate step numbers in the chart. 3. Measure at the harness connector-side. The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure).

Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 1. Turn the key switch to “OFF” for more than 10 seconds. 2. Start the engine. 3. Check the DTC. Is DTC P1271 detected? — Go to Step 3. Go to “Diagnostic aid”. 3 1. Turn the key switch to “OFF”. 2. Disconnect the AP sensor connector. 3. Connect the DMM between the sensor power supply terminal of the AP sensor connector and the ground. 4. Turn the key switch to “ON”. Is the DMM indication more than the specified value? 4.7V Go to Step 5. Go to Step 6. 4 Is the scan tool available? — Go to Step 5. Go to Step 18.