1E-476 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the AP sensor connector. 3. Short between the sensor power supply terminal of the AP sensor connector and the signal terminal using jump cable. 4. Turn the key switch to “ON”. 5. Check for “Accelerator sensor 1” on the data display using scan tool. Is the “Accelerator sensor 1” more than the specified value? 4.7V Go to Step 8. Go to Step 7. 6 1. Check for high resistance in the power supply circuit between ECM and AP sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:
If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 16. Go to Step 11. 7 1. Check for high resistance in the signal circuit between ECM and AP sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 16. Go to Step 11. 8 1. Check for high resistance in the ground circuit between ECM and AP sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:
If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 16. Go to Step 11.