Electronic control fuel injection system (Common rail type) 1E-477 Step Action Value YES NO 9 1. Check for high resistance in the signal circuit between ECM and AP sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 16. Go to Step 11. 10 1. Turn the key switch to “OFF”. 2. Disconnect the AP sensor connector. 3. Check the AP sensor connector terminal for intermittent trouble or poor contact. 4. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 16.
Go to Step 12. 11 1. Turn the key switch to “OFF”. 2. Remove the ECM. 3. Check the ECM terminals (41, 63, 42, 60, 64, 61) for intermittent trouble or poor contact. 4. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 16. Go to Step 13. 12 Replace the AP sensor. Is the procedure completed? — Go to Step 16. — 13 Is EMPS available? — Go to Step 14. Go to Step 15. 14 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.
Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 16. Go to Step 15.