1E-478 Electronic control fuel injection system (Common rail type) About AP sensor Characteristics of AP sensor Refer to the machine’s manual for installing position of the AP sensor. (V) 4 1 0 99.8 (%) TSWG0200 Step Action Value YES NO 15 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 16. — 16 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.
Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P1271 detected? — Go to Step 2. Go to Step 17. 17 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 18 1. Turn the key switch to “OFF”. 2. Disconnect the AP sensor connector. 3. Turn the key switch to “ON”. 4. Connect the DMM between the sensor power supply terminal of the AP sensor connector and the signal circuit. Is the DMM indication more than the specified value?
4.7V Go to Step 8. Go to Step 7.