hitachi — Injector balance test

Electronic control fuel injection system (Common rail type) 1E-43 5. Send the instruction to RPCV and check the data list. Injector balance test This test is performed to confirm that proper electric signal is sent to injector while the engine is running. Note: At test, the engine is controlled to low idle speed, in order to clarify the variation of engine speed. Test procedure 1. Connect the Tech2 to the machine DLC. 2. Start the engine and run it at idle. 3. Select the Common Rail System. 4. Select Injection Stop for Each Injector. TSWG0147 6. If variation of data list is proper value, RPCV is judged as normal. 5.

Send instruction to each injector (set to OFF by softkey on Tech2 screen) to stop the injector, and check the variation of engine speed. TSWG0138 TSWG0139 RPM MPa V V RPM RPM V V %