1E-44 Electronic control fuel injection system (Common rail type) 6. If the engine speed varies when the injector stops, electrical circuit of that injector is judged as normal. If the engine speed does not vary when the injector stops, electrical circuit of that injector or injector body is judged as faulty. 6. If the operation sound is heard, electrical circuit of that injector is judged as normal. If the operation sound is not heard, electrical circuit of that injector or injector body is judged as faulty. Note: After injector control test, the key switch must be turned to OFF once to restart.
Injector control test This test is performed to confirm that proper electric signal is sent to each injector. The Tech2 must be used in this test. Test procedure 1. Connect the Tech2 to the machine DLC. 2. Turn the key switch to ON (engine is standstill). 3. Select the Common Rail System. 4. Select Compulsory Drive of Injector. Glow time relay test This test is performed to check the operation of QOS lamp. The Tech2 must be used in this test. Test procedure 1. Connect the Tech2 to the machine DLC. 2. Turn the key switch to ON. 3. Select the Device Control. TSWG0131 5. Send instruction to each injector (set to ON by softkey on Tech2 screen), and check the operation sound of injector.
TSWG0137 4. Select the Glow Plug Relay. TSWG0132 TSWG0133 V V RPM RPM V V %