hitachi — DTC: P1278 (Flash code 24) Accelerator sensor 1 fault (high voltage fault)

Electronic control fuel injection system (Common rail type) 1E-485 DTC: P1278 (Flash code 24) Accelerator sensor 1 fault (high voltage fault) A A Engine control module (ECM) CAN HIGH CAN LOW 37 E-57 18 E-57 60 E-57 20 E-57 41 E-57 63 E-57 42 E-57 64 E-57 61 E-57 71 E-57 72 E-57 Machine control unit CAN HIGH CAN LOW 6 FL-167 5 FL-167 4 FL-167 6 FL-167 5 FL-167 4 FL-167 1 FL-269 2 FL-269 3 FL-269 2 FB-124 1 FB-124 Intake air temperature sensor Barometric pressure sensor Accelerator position sensor TSWG0081 Description of circuit Main trouble symptom The accelerator position (AP) sensor is installed to the accelerator pedal.

The AP sensor is the potentiometer- type sensor, and the value of output voltage changes according to the accelerator opening angle. The AP sensor includes following circuits. 5-V power supply circuit Ground circuit AP sensor signal circuit The ECM provides 5 V to the AP sensor through 5-V power supply circuit, and grounds to the inside of the ECM through ground circuit. Also, the AP sensor outputs the signal voltage to the ECM through AP sensor signal circuit. The AP sensor 1 outputs high voltage when the accelerator opening angle is large. The ECM sets the DTC when the signal voltage from the AP sensor 1 is more than the normal range. 1 system fault: No backup 2 systems fault:

Accelerator opening angle is controlled to 0%. Preconditions when DTC is set Key switch input voltage is 16V or more. DTC P1630, P1278, or P1631 is not detected. DTC set condition AP sensor 1 voltage is 4.9 V or more. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Accelerator Accelerator position position sensor 1 signal sensor 2 signal 5V Intake air Barometric pressure temperature sensor signal sensor signal 5V Vcc