hitachi — DTC: P1630 (Flash code 36) A/D conversion fault

1E-512 Electronic control fuel injection system (Common rail type) DTC: P1630 (Flash code 36) A/D conversion fault Description of circuit The ECM processes the analog signals (voltage signal etc.) which are input from each sensor into digital signals, to perform various controls and calculations. The ECM sets the DTC when the fault is detected for the analog-digital conversion. Back-up mode Analog sensor system default processing Limited injection amount 3 (multi-injection stopped) Target RP upper limit (80 MPa {11603 psi}) Recovery from failure Main trouble symptom Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.

Output lowering Black smoke emitted The conditions to clear the MIL/DTC DTC set condition Analog/digital conversion failure The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2.

Go to “OBD system check”. 2 Check the DTC again. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3. Test run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC P1630 detected? — Go to Step 3. Go to “Diagnostic aid”. 3 Is EMPS available? — Go to Step 4. Go to Step 5. 4 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note:

EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 6. Go to Step 5.