hitachi — DTC: P1625 (Flash code 416) Main relay fault

Electronic control fuel injection system (Common rail type) 1E-511 On-board check procedure for sensors 3 1 2 4 TSWG0197 Name 1. Coupling connector between engine — the machine 2. Machine harness 3. Sensor connector 4. Engine harness 1. Disconnect the coupling connector, and check the sensor from engine harness connector. 2. Disconnect the connector from sensor, and short the wiring of sensor connector. 3. Check the harness from coupling connector for open circuit. If both steps 1 and 2 are faulty, repair the harness. Check from step 1 again. If only step 1 is faulty, replace the sensor. Step Item to be checked Inspection method Measuring condition Terminal No.

Normal value Abnormal value 6 Short circuit to power supply circuit Voltage measurement • Disconnect the relay. • Key switch “ON” 2 - Ground 5 - Ground 0V 18V or more 10 Open circuit/ high resistance Resistance measurement • Disconnect the relay. • Key switch “OFF” 2 - Relay installing terminal No. 2 5 - Relay installing terminal No. 2 21 - Relay installing terminal No. 5 40 - Relay installing terminal No. 5 100 Ω or less 10 MΩ or more Short circuit to ground Resistance measurement • Disconnect the relay. • Key switch “OFF” 2 - Ground 5 - Ground 21 - Ground 40 - Ground 10 MΩ or more 100 Ω or less