1E-48 Electronic control fuel injection system (Common rail type) 4. After all the values have been entered, press the softkey “Set Clock” and the changes will be saved. Rewrite setting of Q adjust correction data by Tech2 “Q adjust, Injector code label” is attached to the cylinder head cover. It is used for rewriting and registering the ID. 1 2 3 4 TSWG0144 Set units Operation procedure: 1. Choose the “F2: Tool Options” and press [ENTER]. 2. Choose the “F2: Set Unit” and press [ENTER]. 3. Display the “Set Unit” screen. Then move the cursor to the item you want changed by operating the selection keys ( ), and press [ENTER] key. 4.
When the setup is complete, press the [EXIT] key to save the current setting. Name 1. Engine number 2. Typical engine model 3. Q adjust information 4. Injector information TSHK0098 There is the injector code on the top of injector as well. When replacing the injector, register its code. 1. Refer to the following instruction for how to setup the Q adjust data. Step 1 Press [ENTER]. Note: It will take effect next time the Tech2 is switched on. TSWG0145 * Metric Temperature: ° C Speed: km/h * English Temperature: ° F Speed: MPH TSWG0110