1E-528 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Check the power supply circuit between common rail pressure sensor and ECM for ground short circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 9. Go to Step 61. 6 Is EMPS available? — Go to Step 7. Go to Step 8. 7 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note:
EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 9. Go to Step 8. 8 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 9. — 9 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.
Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P1635 detected? — Go to Step 2. Go to Step 10. 10 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair.