hitachi — DTC: U2104 (Flash code 84) CAN Bus fault

Electronic control fuel injection system (Common rail type) 1E-529 DTC: U2104 (Flash code 84) CAN Bus fault CAN HIGH CAN LOW Engine control module (ECM) KWP2000 52 E-57 38 E-57 37 E-57 4 E-57 3 E-57 1 E-57 43 E-57 62 E-57 81 E-57 18 E-57 6 FL-150 7 FL-150 DLC 4 FL-150 5 FL-150 Machine control unit CAN HIGH CAN LOW TSWG0074 Description of circuit Preconditions when DTC is set The ECM communicates with the machine control unit (ECU) through CAN communication circuit. The ECM data outputs through the CAN-High circuit, and other ECU data inputs through the CAN-Low circuit.

The CAN communication performs at a constant speed without interruption, and the number of data outputs and inputs must always be the same. The ECM sets the DTC when the fault is detected for the CAN communication. Key switch input voltage is 12V or more. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode Main trouble symptom • Specified back-up value Vary depending on setting. DTC set condition Recovery from failure CAN communication fault Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.