hitachi — DTC: U2104 (Flash code 84) CAN Bus fault

1E-530 Electronic control fuel injection system (Common rail type) The conditions to clear the MIL/DTC Test description The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Numbers below indicate step numbers in the chart. 2. If no DTC is detected, intermittent trouble is suspected. Identify the cause by referring to “Diagnostic aid”. 5. Measure at the harness connector-side. Step Action Value YES NO 1 Perform the OBD check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 1.

Turn the key switch to “OFF” for more than 10 seconds. 2. Start the engine. 3. Check the DTC. Is DTC U2104 detected? — Go to Step 3. Go to “Diagnostic aid”. 3 1. If the DTC U2104 is detected, and the history and present troubles of DTC U2106 are alternately detected, check the circuit between ECM terminals (32) and (18) for the following conditions. • Short circuit 2. If the trouble is detected, repair or replace as required. 3. Check if DTC is not detected again. Is the procedure completed? — — Go to Step 4. 4 Is the breaker box available? — Go to Step 5. Go to Step 15. 5 1. Turn the key switch to “OFF”. 2. Remove the ECM. 3. Connect the breaker box to the ECM. 4.

Connect the breaker box with the ECM harness. 5. Measure the resistance between the CAN-High-side terminal and CAN-Low- side terminal using breaker box. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. Is the resistance within the specified value? 50 — 70Ω Go to Step 13. Go to Step 6. 6 1. Remove the ECM from the breaker box. 2. Measure the resistance between the CAN-High-side terminal and CAN-Low- side terminal using breaker box. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. Is the resistance specified value? Approx.

120Ω Go to Step 7. Go to Step 8.