hitachi — DTC: U2104 (Flash code 84) CAN Bus fault

Electronic control fuel injection system (Common rail type) 1E-531 Step Action Value YES NO 7 1. Connect the ECM to the breaker box. 2. Remove the machine control unit and the harness. 3. Measure the resistance between the CAN-High-side terminal and CAN-Low- side terminal using breaker box. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. Is the resistance specified value? Approx. 120Ω Go to Step 13. Go to Step 10. 8 1. Check the CAN-Low circuit and CAN- High circuit between ECM and machine control unit for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM.

Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, replace the harness. Is the trouble detected? — Go to Step 2. Go to Step 9. 9 1. Check for followings in the CAN-Low circuit and CAN-High circuit between ECM and machine control unit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance • Short circuit to ground 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 2. Replace the machine control unit.

10 Is EMPS available? — Go to Step 11. Go to Step 12.