hitachi — DTC: U2104 (Flash code 84) CAN Bus fault

1E-532 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 11 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Verify repair. Go to Step 12. 12 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.

Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. — 13 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC U2104 detected? — Go to Step 2. Go to Step 14. 14 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair.

15 Remove the ECM, and measure the resistance between the CAN-High-side terminal and CAN-Low-side terminal of the ECM connector. Is the resistance specified value? Approx. 120Ω Go to Step 16. Go to Step 8. 16 1. Install the ECM, and remove the machine control unit. 2. Measure the resistance between the CAN-High-side terminal and CAN-Low- side terminal of the machine control unit connector. Is the resistance specified value? Approx. 120Ω Go to Step 13. Go to Step 10.