1E-536 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 4 1. Check for followings in the CAN-Low circuit and CAN-High circuit between ECM and machine control unit (ECU) using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to ground circuit • Short circuit to power supply circuit or ignition power supply circuit 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 11. Go to Step 5. 5 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.
Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC U2106 detected? — Go to Step 6. Go to “Diagnostic aid”. 6 1. If the DTC U2104 is detected, and the history and present troubles of DTC U2106 are alternately detected, check the circuit between ECM terminals (32) and (18) for the following conditions. • Short circuit 2. If the trouble is detected, repair or replace as required. 3. Check if DTC is not detected again. Is the procedure completed? — — Go to Step 7.
7 Replace the machine control unit. Is the procedure completed? — Go to Step 11. — 8 Is EMPS available? — Go to Step 9. Go to Step 10.