hitachi — DTC: U2106 (Flash code 85) CAN timeout fault

Electronic control fuel injection system (Common rail type) 1E-535 Recovery from failure Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part.

Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Test description Numbers below indicate step numbers in the chart. 2.

If no DTC is detected, intermittent trouble is suspected. Identify the cause by referring to “Diagnostic aid”. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 1. Turn the key switch to “OFF” for more than 10 seconds. 2. Start the engine. 3. Check the DTC. Is DTC U2106 detected? — Go to Step 3. Go to “Diagnostic aid”. 3 1. Check for followings in the CAN-Low circuit and CAN-High circuit between ECM and machine control unit (ECU) using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”.

• Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 11. Go to Step 4.