1E-534 Electronic control fuel injection system (Common rail type) DTC: U2106 (Flash code 85) CAN timeout fault CAN HIGH CAN LOW Engine control module (ECM) KWP2000 52 E-57 38 E-57 37 E-57 4 E-57 3 E-57 1 E-57 43 E-57 62 E-57 81 E-57 18 E-57 6 FL-150 7 FL-150 DLC 4 FL-150 5 FL-150 Machine control unit CAN HIGH CAN LOW TSWG0074 Description of circuit DTC set condition The ECM communicates with the machine control unit (ECU) through CAN communication circuit. The ECM data outputs through the CAN-High circuit, and other ECU data inputs through the CAN-Low circuit.
The CAN communication performs at a constant speed without interruption, and the number of data outputs and inputs must always be the same. The ECM sets the DTC when the CAN communication is disrupted with the machine control unit (ECU). Instruction message on CAN communication to run is disrupted for 1 second or more. Preconditions when DTC is set DTC U2104 is not detected. Key switch input voltage is 12V or more. Action taken when DTC is set Main trouble symptom Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Vary depending on setting. It cannot be controlled from the machine side since CAN communication is disabled.
The engine speed becomes back-up speed specified by each machine manufacturer. Back-up mode • Specified back-up value