1E-544 Electronic control fuel injection system (Common rail type) Engine stall Pre-inspection Pipes and hoses relevant to fuel, air and oil are free of crack or twist, and are properly connected. Thoroughly check for any oil leakage and clogging. Fuel system is free from oil leakage, and pipe is not damaged or dent. Intake system parts for fault. Exhaust system parts for fault. Before using this paragraph, perform the “OBD system check” and check all the following items. Check if excessive load is applied to the machine side. ECM and diagnosis lamp operate properly.
To detect crank sensor fault, crank more than 60 rpm for 14 seconds or more since it is not judged on cranking for less than 14 revolutions. Check the DTC. When the engine is running at low speed, the DTC of crank sensor fault may not be detected. If an intermittent trouble is found, raise the engine speed up to No Load Max, and check if DTC related to crank sensor is detected. Scan tool data shows normal operating range. Check the condition of the machine to identify the applicable symptom from “List of trouble symptom”. Perform the procedure described in the symptom chart. Check with the customer if correct engine oil and fuel are used.
Diagnostic aid Fuel system fault (run out of fuel, frozen fuel, air mixed in fuel pipe, faulty filter [clog in main filter, gauze filter], pipe fault, fuel quality, fuel tank [foreign matter, fuel suction fault]) Intake system fault (clogging in filter, intake pipe fault, etc.) Supply pump fault (no fuel pressure feed) Common rail fault (flow damper or pressure limiter is activated, degradation of sealability) Injector fault (no fuel injection) System down due to trouble Engine body fault (seizure, compression pressure shortage, other mechanical trouble) ACG trouble Machine side related equipment trouble (oil pressure pump etc.) Effect of commercial electrical equipment (radio, lamp, etc.) ECM trouble (body, power supply, ground, etc.) Check the connector for poor contact, the harness for fault such as wear or bend, and the wire inside the harness for loosened wire causing short circuit to other circuits.
Also, perform the function diagnosis to check the operation and control of each part. Repair if faulty. Visual check Careful visual check is required for some symptom procedures. By this inspection, the problem can be corrected without performing further inspection, and time can be saved. This inspection includes the following items. There is no poor contact in connector (it must be connected with click sound). Especially for CKP sensor and G sensor. Wire is connected, tightened or cut properly. Commercial accessory power supply is not bifurcated from ECM power supply. ECM ground is not contaminated and installed to the proper position securely.
Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check if excessive load is applied to the machine side. Repair or replace the faulty part. Note: Refer to the machine’s manual for check and repair. Is the procedure completed? — Go to Step 3. —