hitachi — Engine stall

Electronic control fuel injection system (Common rail type) 1E-545 Step Action Value YES NO 3 Check the electrical system. 1. Crank sensor fault is not judged on cranking for less than 14 revolutions. Crank the engine at 60 rpm or more for 14 seconds or more, or raise the engine speed up to No Load Max, and check if DTC is detected. 2. Check the connectors of the ECM, fuel pump, ACG and electronic governor for poor contact or play. Note: Poor contact in the connector, especially CKP sensor and G sensor, causes engine stall. It must be connected with click sound. 3. Check the harness for open or short circuit. 4. Repair or replace the faulty part. Is the procedure completed? — Go to Step 4.

— 4 Check the ACG. Check if the charge warning lamp turns on while engine is running. Note: Refer to the machine’s manual for charge warning. Does the charge warning operate? — Go to Step 6. Go to Step 5. 5 Replace the ACG. Also, check the charge warning system, and repair or replace if faulty. Is the procedure completed? — Go to Step 6. — 6 Check the condition of commercial electrical equipment such as radio and lights. Does the engine stall when the commercial electrical equipment is powered OFF? — Go to Step 7. Go to Step 8. 7 Correct the installation condition of the electrical equipment, or remove the electrical equipment. Is the procedure completed? — Go to Step 8. —