hitachi — Engine stall

1E-546 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 8 Check the fuel system in the following procedure. 1. Check the high pressure pipe and low pressure pipe for looseness in the connection (fuel leakage), crush or clogging. Check the clogging in the following procedure. • Fuel filter (main fuel filter, pre-fuel filter, gauze filter) • Fuel tank (pump strainer) • Fuel system pipe 2. Check the fuel pipe, fuel filter, and inside of the fuel tank for freeze or waxing. (at cold temperature) 3. Check the feed pipe inside the fuel tank for clogging of foreign matter. 4. Repair or replace the faulty part. Is the procedure completed? — Go to Step 9.

— 9 Check the intake system. Is the procedure completed? — Go to Step 10. Go to “Intake system check”. 10 Check the exhaust system. Is the procedure completed? — Go to Step 11. Go to “Exhaust system check”. 11 Check the mechanical part of the engine, and repair if faulty. • Compression pressure • Valve system • Injector • Timing gear • Related part of piston/crank Is the procedure completed? — Go to Step 12. — 12 Is EMPS available? — Go to Step 13. Go to Step 14. 13 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note:

EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Verify repair. Go to Step 14.