Electronic control fuel injection system (Common rail type) 1E-549 Step Action Value YES NO 4 Bleed air from fuel, and check for trouble symptom again. Note: For work procedure, refer to “Engine section” in the service manual. Is the engine symptom corrected? — Go to Step 24. Go to Step 5. 5 Check the intake system. Is the procedure completed? — Go to Step 6. Go to “Intake system check”. 6 Check the fuel system. Is the procedure completed? — Go to Step 7. Go to “Fuel system check”. 7 Check the injector. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Start the engine. 3.
Select the “Actuator test” from the scan tool menu. When the scan tool is not available, refer to “How to Inspect Injector” in this section. 4. Select the “Injection stop at each injector” in the “Common rail system”. 5. Press the “OFF” soft key to stop the fuel injection in the cylinder one by one, and check the change in engine sound. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 8. Go to Step 9. 8 Replace the injector in the cylinder of which engine sound did not change when it is stopped. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 9.
— 9 Check for the engine symptom again. Is the engine symptom corrected? — Go to Step 22. Go to Step 10. 10 Check the condition of commercial electrical equipment such as radio and lights. Does the engine symptom change when the commercial electrical equipment is powered OFF? — Go to Step 11. Go to Step 12. 11 Correct the installation condition of the electrical equipment, or remove the electrical equipment. Is the procedure completed? — Go to Step 12. —