hitachi — Engine hunting, rough idling

1E-550 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 12 Check for installation condition of the crankshaft position (CKP) sensor and G sensor. Check the CKP sensor and G sensor for improper installation such as play. Is it properly installed? — Go to Step 14. Go to Step 13. 13 Correct the installation condition of the CKP sensor and G sensor. Is the procedure completed? — Go to Step 14. — 14 Is the scan tool available? — Go to Step 15. Go to Step 16. 15 Check the signal conditions of CKP sensor and G sensor using scan tool. 1. Connect the scan tool. 2. Crank the engine. 3. Correct the data list on the scan tool. Is the speed displayed? — Go to Step 18.

Go to Step 16. 16 Check for signal detection condition of the CKP sensor. 1. Start the engine. 2. Remove the harness from the G sensor. (The DTC is detected when this procedure is performed. Be sure to clear the DTC after repairing the machine.) Is the idle condition normal? — Go to Step 23. Go to Step 17. 17 Check for signal detection condition of the G sensor. 1. Start the engine. 2. Remove the harness from the CKP sensor. (The DTC is detected when this procedure is performed. Be sure to clear the DTC after repairing the machine.) Is the idle condition normal? — Go to Step 23. Go to Step 18. 18 Check for the engine symptom again. Is the engine symptom corrected? — Go to Step 24.

Go to Step 19. 19 Is EMPS available? — Go to Step 20. Go to Step 21. 20 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 24. Go to Step 21.