Electronic control fuel injection system (Common rail type) 1E-555 Step Action Value YES NO 15 Replace the injector in the cylinder of which engine sound did not change when it is stopped. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 15. — 16 Is EMPS available? — Go to Step 17. Go to Step 18. 17 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.
Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 20. Go to Step 18. 18 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 20. Go to Step 19. 19 Restore the ECM to its original condition of before replacement. Note: EGR valve position learning is required after replacing or rewriting the ECM.
Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 20. — 20 Check the mechanical part of the engine, and repair if faulty. • Compression pressure • Valve system • Injector • Timing gear • Related part of piston/crank Is the procedure completed? — Go to Step 21. — 21 Check the machine-side equipment (trouble of oil pressure pump etc.), and repair if faulty. Is the procedure completed? — Go to Step 22. —