1E-554 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 6 Bleed air from fuel, and check for trouble symptom again. Note: For work procedure, refer to “Engine section” in the service manual. Is the engine symptom corrected? — Go to Step 22. Go to Step 7. 7 Check the fuel system. Is the procedure completed? — Go to Step 8. Go to “Fuel system check”. 8 Check the intake system. Is the procedure completed? — Go to Step 9. Go to “Intake system check”. 9 Check the exhaust system. Is the procedure completed? — Go to Step 10. Go to “Exhaust system check”. 10 Check for the engine symptom again. Is the engine symptom corrected? — Go to Step 22. Go to Step 11.
11 Check the condition of commercial electrical equipment such as radio and lights. Does the engine symptom change when the commercial electrical equipment is powered OFF? — Go to Step 12. Go to Step 13. 12 Correct the installation condition of the electrical equipment, or remove the electrical equipment. Is the procedure completed? — Go to Step 13. — 13 Check for the engine symptom again. Is the engine symptom corrected? — Go to Step 22. Go to Step 14. 14 Check the injector. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Start the engine. 3.
Select the “Actuator test” from the scan tool menu. When the scan tool is not available, refer to “How to Inspect Injector” in this section. 4. Select the “Injection stop at each injector” in the “Common rail system”. 5. Press the “OFF” soft key to stop the fuel injection in the cylinder one by one, and check the change in engine sound. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 15. Go to Step 16.