hitachi — Exhaust gas contains a lot of white smoke.

Electronic control fuel injection system (Common rail type) 1E-557 Exhaust gas contains a lot of white smoke. Pre-inspection Commercial accessory power supply is not bifurcated from ECM power supply. ECM ground is not contaminated and installed to the proper position securely. Pipes and hoses relevant to fuel, air and oil are free of crack or twist, and are properly connected. Thoroughly check for any oil leakage and clogging. Fuel system is free from oil leakage, and pipe is not damaged or dent. Intake system parts for fault. Exhaust system parts for fault. Before using this paragraph, perform the “OBD system check” and check all the following items. ECM and diagnosis lamp operate properly.

Check the DTC. Scan tool data shows normal operating range. Check the condition of the machine to identify the applicable symptom from “List of trouble symptom”. Perform the procedure described in the symptom chart. Check with the customer if correct engine oil and fuel are used. Diagnostic aid Visual check Careful visual check is required for some symptom procedures. By this inspection, the problem can be corrected without performing further inspection, and time can be saved. This inspection includes the following items. There is no poor contact in injector connector (it must be connected with click sound). Wire is connected, tightened or cut properly.

Fuel quality (use of fuel other than specified) Long-term idling Trouble of engine coolant temperature (ECT) sensor, fuel temperature (FT) sensor, intake air temperature (IAT) sensor, boost pressure sensor, or barometric pressure sensor. Engine body trouble (compression pressure shortage, related to piston, turbocharger, rise/ decline of oil, etc.) ECM trouble (body, power supply, ground, etc.) Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check the fuel. 1. Replace the fuel tank and the fuel in the pipe, or supply the specified oil suitable for current environment from the fuel container. 2.

Start the engine, operate the machine, and check for trouble symptom. Is the engine symptom corrected? — Go to Step 17. Go to Step 3. 3 Check the fuel system. Is the procedure completed? — Go to Step 4. Go to “Fuel system check”. 4 Check if oil is mixed in the intake air. 1. Is the blow-by emitted excessively? • Excessive engine oil • Clogged or deformed oil return pipe • Clogged or crushed breather hose 2. Wear of turbocharger seal ring 3. Repair or replace the faulty part. Is the procedure completed? — Go to Step 5. — 5 Is the scan tool available? — Go to Step 6. Go to Step 8.